20

Mar 14

HOW TO CLEAN A SMELLY FRONT LOADING WASHING MACHINE AND MAKE IT STAY CLEAN

If you have noticed that your clean clothes smell like mildew even after you wash them, keep reading. May be your front loading washing machine need some attention.
The drums on washing machines, top and front loaders, spin around a centripetal force – the water spins outward from the center, exiting through the holes on the sides of the drum. Excuse the scientific lingo here but the centripetal force is more effective in draining the water when the drum is spinning around a Y-axis or horizontally, as in top loader and not around a X-axis or vertically, as in front loader. So, there’s always a chance that not all of the water gets drained from the machine if the drum is lying on its side, as in front loaders. The result is water pooling in the rubber gasket that seals the door, allowing odor causing bacteria, mold and mildew to grow. And add some lint, hair, dust, and whatever gets shaken out of the clothes to the mix and you have a sludge that resembles an industrial toxic waste, sitting there adding foul smell to the wash, toxic mildew and mold growing. Gross. Toxic. Unhealthy.
But don’t worry, you don’t have to throw your machine away. There are some very simple things you can do to bring it back to life.

HOW TO CLEAN AND MAINTAIN A SMELLY FRONT LOADING WASHING MACHINE

1. Wipe Down – Every time you finish your load, wipe down the water and soak up any remaining water inside the gasket. Peel back the rubber door seal, and clean in there. You’ll notice little grooves. Water sits here, and with collected dust and lint from the clothes, the gunk just accumulates into a sludge that stinks. Wrap your finger with a paper towel, stick in the grooves, and spin the washer slowly. You’ll notice there are draining holes. Clean the holes well.

2. Unload the finished load immediately. Do not let wet clothes sit in the machine for obvious reasons. If you can’t take them out in a timely manner, use the delay washing feature and time the finishing time when you can take them out right away.

3. Leave the door open when not in use to allow the water and moisture to evaporate and not stay inside stagnantly. Be careful with this if you have young children or pets; cats love to crawl inside crevices and this can be a perfect spot for catnaps. Actually, they recommend leaving the lids open for top loaders for same reasons too.

4. Run a HOT cleaning cycle with an empty washer at least once a week. The frequency depends on how many loads of washes you do but in general, once a week of a quick cleaning should be sufficient. Use 50/50 vinegar/water solution to wipe the gasket clean. Don’t forget to clean the inside rim of the glass door as well as the glass.

5. Once a month, add a cup of Distilled White Vinegar & 1 Cup of Baking Soda (adding both neutralizes the pH but the bubbling action gently scrubs any debris you can’t get to inside the drum) directly into the drum and use HOT water for washing. Then, add about ½ cup of vinegar into the fabric softener compartment and ½ cup of baking soda into the detergent compartment. If you have a “Cleaning Cycle”, use it or set the wash on “Quick Wash” with HOT water and High Spin Cycle.

6. Bleach – If the mold situation is really bad, you may need to use bleach instead of vinegar and baking soda. But make sure you run a few empty cycles just with hot water before doing a load of wash. Otherwise, you may end up with tie dyed shirts.

7. Use eco-friendly High Efficiency (HE) detergents. If the detergent is concentrated, use half as much. HE detergents produce less suds and has less fragrance than regular detergents. The volume of suds produced by regular detergents acts like sludge to water draining out of the tub. Also, their fragrances mix with the mildew-y water produce even worse smell. That goes for the fragrant fabric softeners. The chemicals in the slimy thick fabric softeners, even the eco-friendly ones, are guilty of contributing to the foul smelling sludge. Use eco-friendly dryer sheets or dryer sachets instead.

8. Clean the detergent compartment drawer. You can easily take the drawer out – read the machine’s manual – and clean the soap, bleach, and fabric softener compartments. Soak it in warm water with dishwashing liquid or vinegar/baking soda mix. Use an old tooth brush if you have to.

9. Finally, clean the drain pump filter. This should be done about every two weeks. If the drain pump filter gets clogged with debris, the water flow will slow down, and fill up with stinky water over time. Old water that didn’t drain sits here, as does lint and other odd items. The drain pump filter is usually located at the front bottom of the washer. Refer to your washer manual as different machines have different instructions but the bottom line is that it needs to be cleaned out so that water doesn’t sit in the pump.

yes, it might sound like too much work, but if you take care of your appliances, they perform better and last longer.